Kiwi Milsim - Universal Auto-Feed Wiring for AEG, Polarstar and Wolverine FCU

The Kiwi Milsim HPA FCU wiring harness is finally here! Designed for (almost) plug and play operation, this unit acts as a control switch between your AEG gearbox, Polarstar FCU or Wolverine FCU and your Kiwi Milsim box mag. This switch stays installed on your replica, and will plug in to all Kiwi Milsim boxes and inserts.

Note that this setup requires the use of the on board box mag battery in order to run the box, which means that your AEG's battery or 7.4V FCU battery only powers the replica, and your choice of battery only powers the box mag motor (eg a 12V battery to reach your boxes full potential). 

This product comes with the Polarstart FCU MCU port adapter wire for your Polarstar Rev3 FCU, and a bare wire adapter for your Wolverine FCU and AEG gearboxes.

CUSTOMER IS RESPONSIBLE FOR CORRECTLY SOLDERING THE WIRES IN PLACE (IF REQUIRED).

NOT TESTED WITH ANY OTHER HPA SYSTEM, USE AT YOUR OWN RISK.