The Kiwi Milsim Pressure Pad is our way of activating the all of our box magazines. Built on a sturdy 1.6mm printed circuit board mounting up to four momentary on tactile switches and wired to a 15cm male JST connector, the chances of failure are almost nonexistent. Each switch comes with an 17cm JST-connected extension wire to allow the user to route the wire anywhere desired. Available in a variety of configurations:
The standard pressure pad; simply the switch wrapped in secure heat shrink. Allows you to place the switch wherever desired with your own mounting solution.
The rail cover securely retains a full length (4 tactile switch) pressure pad on any picatinny rail. With an overall length of 90mm and only adding 10mm to the height of your rail, this pressure pad is sleek and easy to handle. Includes pressure pad and associated mounting hardware.
Everyone loves an angled grip! And this is no different. Features a full length Kiwi Milsim pressure pad integrated conveniently placed under the shooter's fintertips, along with hand stops both fore and aft to prevent slipping. Includes pressure pad and associated mounting hardware. (normally places switches on replica's right side, if you want it on the left side, please message us!)
The classic vertical grip. Along with the integrating of a full size Kiwi Milsim pressure pad, there is the flexibility to change the orientation of the grip to eight locations around the base. This is done by simply removing and reinstalling the 3mm screw from the grip base. Also features knurling for enhanced grip in all environments. Includes pressure pad and associated mounting hardware.
